Showing results: 61 - 75 of 1675 items found.
-
IS-*MT -
Lisun Electronics Inc.
According to requirement of IEC standards, the standard test temperature is 25℃, but high power lamps such as HID lamps and LED outdoor luminaires will produce a lot of heat during the test, thus the temperature inside the integrating sphere can not meet the requirements of IEC standards. Lisun Group designed the Constant Temperatured Integrating Sphere which allows the lamp was tested in a constant air temperature.
-
MM14 -
D.Marchiori s.r.l.
The MM14 is a digital technology pressure standard calibrator. It consists of a variety of components combined to allow ease of operation for the verification of pressure based UUTs (unit under test) such as Air Data Test Sets.The MM14 utilises a very accurate dual pressure transfer standard generator, a reference Primary Standard dead-weight and PC based operating system for automatic verification of the U.U.T.
-
NSG 5071 -
Teseq AG
The basic philosophy of this test circuit is better reproducibility of actual switching transients. The reproducibility of this test circuit comes not from the output characteristics as in traditional conducted automotive immunity tests, but from a fixed design of the generator using several pre-defined components. Many of these components are defined in the standard as "critical" with no substitutions allowed. These components are used as required in the standard.
-
Rohde & Schwarz GmbH & Co. KG
EMI test receivers; extremely accurate instruments designed to detect electromagnetic emissions rigorously, to ensure all emissions conform to the Standard being tested to. Configured to set up running the required tests for parameters defined by the Standards as simply as possible, including automated test routines. R&S EMI test receivers can be much more too, with a full signal and spectrum analyzer in the same instrument.
-
7Layers, Inc.
During the development phase of new products, we analyze the weak points in simulation tests and test the products for environmental influences. The relevant standards are used as the basis for the simulation tests.
-
SY8506 -
Hong Kong Songyang Industrial Ltd.
The test of the error of the rate of flow:Using the gas flow standard device (in the shape of the bell prover) as our standard equipment, we can figure the standard volume of the tested gas by using the high-precision revolving encoder to measure the descending displacement of the bell prover.
-
DIF-KIT -
KANOMAX USA, Inc.
The Kanomax tracer gas diffuser kit is used in performing tracer gas tests in accordance with ANSI / ASHRAE Standard 110. The diffuser is designed to the specifications of standard drawing #110-83M.
-
-
-
-
TF-24 -
Lumetronics
Are designed to perform tests specified in many standards to determine compliance with safety requirements.
-
Qosmotec Software Solutions GmbH
Qosmotec test systems are expandable to adapt your automation environment to increased demands. Standard components that can be easily integrated into an existing test setup are
-
-
ECU-TEST -
Softing Automotive Electronics GmbH
Automotive Electronics - ECU-TEST is the universal test automation ECU-TEST was designed for test automation and for the validation of ECUs. Standard test tools are already integrated and can be used together in tests. ECU-TEST is used to design, realize, run and evaluate tests.
-
National Technical Systems
When the required testing of a product includes a transport simulation test, there are several standards that various organizations have published for package testing methods. These include the International Organization for Standardization (ISO), American Society for Testing and Materials (ASTM), Military Standards (MIL-STD-810), and in more recent years the International Safe Transit Association (ISTA) whose test standards are becoming more widely accepted.
